This star is a variation on the pattern I taught at my home this month at my first ever tat days in Southwestern Ohio.
Begin with a ball of thread and one shuttle about half full with any thread CTM . My sample is Flora size 20 and the finished star is about 3" in diameter.
The Balanced Double Stitch ( BDS ) allows you to tat a long chain that will lie fairly straight. Tension should be snug and every 5 or 10 stitches push the BDS together into a straight line.
Instructions:
The first ring is a "REVERSE RING" which means that you tat the entire ring as if it were the second half of a split ring. This allows you to "throw off" another ring which ends up being the center ring of the star.
Round One
Reverse Ring ( 8 - 2 - 3 ( Thrown off ring ( 3 - 3 - 3 - 3 - 3 - 3 ) 3 - 2 - 8 ) Turn
Chain (25 BDS ( three seed beads or a large picot ) 25 BDS ) Turn
Ring ( 8 - 2 - 3 + 3 - 2 - 8 ) Turn
This join is skip one picot of the center ring and join to the next.
Chain ( 25 BDS ( three seed beads or a large picot ) 25 BDS ) Turn
Repeat previous ring and chain, then cut leaving thread ends about 10" long. These will be used later.
Round Two
Wind a couple yards onto your shuttle CTM with the ball of thread. Begin on a paper clip or tie a knot between ball and shuttle and tat the 1st BDS the space of a picot from the knot to leave a picot at the beginning of the first chain of Round Two.
Ring ( 8 + 2 + 3 + 2 + 8 ) Turn
Join to the picots of two rings from Round One and to the picot of the center ring between the two rings of Round One.
Chain ( 25 BDS ( three seed beads or a large picot ) 25 BDS ) Turn
This chain weaves over one chain of Round One then under the next as shown in the photo above.
Repeat the ring and chain so that you have three rings in this round, all joined to the rings of the previous round and to the center ring. Remember to weave the chains each time.
Chain ( 25 BDS ) Cut leaving about 10" ends.
Chain ( 25 BDS ) Cut leaving about 10" ends.
Tie the ends through the picot at the beginning of this Round, and tie again leaving about a 6" loop to hang the star or use the ends to sew it onto clothing or glue it to a card hiding the ends in the card.
Weave the last chain of the first round as shown, and tie the ends at the beginning chain of the first round to complete the star. Hide the ends.
Enjoy!
Weave the last chain of the first round as shown, and tie the ends at the beginning chain of the first round to complete the star. Hide the ends.
Enjoy!